Step by step
If your kitchen design includes a fixed drawer front, such as the one below the sink, follow these instructions to install it.
You will need:
- CUBRO front
- Screws no longer than 1.5 cm
- Angle brackets
- It is best to use the brackets that come with the METOD oven or sink cabinet, since you can use the holes that are already machined.
-
- If you have already used them, or you don't have this type of cabinet, you can use any hardware store bracket, but you will probably have to drill another hole.
Installation
- It is recommended to install them before fitting the countertop.
- From above, first attach the brackets to the CUBRO front, one on each side.
- Screw the brackets to the side of the cabinet.
- Adjust if necessary.